Your cart is currently empty!
OME 2″ Lift Rear 2906 Coils for 1996-2002 Toyota 4Runner
Description
OME 2″ Lift Rear 2906 Coils for 1996-2002 Toyota 4Runner
(2) Light Duty 2″ Lift OME 906 Rear Coils for 1996, 1997, 1998, 1999, 2000, 2001, 2002 Toyota 4Runner.
OME-906
A four-wheel drive equipped with an OME Suspension combination will exhibit better towing and load carrying characteristics, improved wheel travel, and will ride and handle better over any road or trail surface.
Product Features
- 906 coils provide approximately 2 inches of lift for 96-02 4Runner. Normal (medium) load.
- Springs are formed on precision mandrels
- Scragging before and after shot peening to prevent sagging
- Durable powder coat finish
- Easy installation. Can directly replace the OE components, no custom installation required.
- Sold in pairs
Note:
Depending on the coil option springs might be different height with taller spring will need to be installed on the driver side to compensate for the drivers weight and/or gas tank on the vehicle
16 reviews for OME 2″ Lift Rear 2906 Coils for 1996-2002 Toyota 4Runner
ATTENTION STATE OF CALIFORNIA CONSUMERS. WARNING: Cancer and reproductive harm – www.p65warnings.ca.gov
Related products
-
-
Radflo 2.5 Body 0-1″ Rear Lift Reservoir Shocks for 1996-2002 Toyota 4Runner
Radflo shocks are build to order. Lead times: 2-3 weeks from day of purchase
(0 reviews)$1,060.00 Add to cart
cole schumann –
They are great, easy to install, delivery was on time!! 5 stars!!
Keith kinowski –
Very happy with the coils as well best price I found delivered on time in excellent condition
Andrew –
Just installed them, no more saggy butt on the 4Runner! Was relatively easy to get these in, and I love the look. Haven’t been able to drive with them much, but I’m looking forward to it.
drj1138 –
No more 4runner saggy butt. Yay!
It is an easy install. No instructions came with the springs so be sure to put the taller spring on the driver side, the same side as the gas tank. Rear shocks are stock length and 4runner drives like I was hoping. I am happy I did this.
jodyomohundro –
Quality product, fast shipping. Install time for me was less than one hour, I encountered no rusted or seize bolts. The new coils made my 01 4Runner sit almost level. I did install new front strut assemblies (shock and spring) a few days prior, that really showed how badly the rear sag was. Front measurement from hub to fender flare bottom edge is 21.5” rear is 22” even, so just a tick higher in the rear. The ride was the biggest improvement, no more hitting the bump stop. Highly recommend this setup.
Omar Salazar –
I did the OME 2″ rear springs paired with the 5100 2″ bilstein shocks, nice lift and smooth ride on my Toyota 4runner 2002 no need for rear or front spacer nice level look. Set the front shocks to the highest setting.
Tam Nguyen –
Excellent, easier way to install it, is to remove your swap bar light, Just un-bolt the nut that holding the link so you have more room to get the spring on. Super fast shipping, got it deliver in 1 day
Cewoz –
Just put in the other day in the middle of doing a muffler replacement the same time and shocks. Definitely a lot easier getting these in then getting the old springs out see the attached picture. The new spring is about a half-inch to three-quarter inch shorter than the stock springs that were on the truck. these springs are definitely be here and have extra runs in the bottom so more than likely won’t sag as much once I put the car back on the ground.
Cewoz –
Great springs easy install on my 1999 Limited. The 5100 shocks on the other hand were a pita…the install on them took longer than a brake job b/c of how tight the space is to tighten the top nut on the shock tower. The new springs are about 1/2 shorter than stock but much beefier, I was a little concerned at first. It is a bit easier to install the springs and shocks without the muffler I replaced that as well.
I still have the stock front coilovers and plan on changing them out when time allows. I can feel the rear lift and the reverse rake is completely gone. Everything rides well and feels great!
Sayer Lane –
Got rid of my sag in the rear! Happy with the ride and handling, hasn’t driven and ridden this well since I’ve had it. No more constant bump stop engagement.
Marc Marcroft –
Absolutely the best thing I could have done… no more sag and it handles great. Curious how much settling will occur but VERY happy at the moment!
Freddy –
Easy and quick install rides great
Joseph Heysquierdo –
Came fast and in time and they helped make my truck look awesome. Will do business again and recommend.
Steve Walker –
I put these on my forerunner which is a 1997 and it’s like a hole different vehicle…! Unbelievable difference in handling. I’m pulling a 3500lb. 21 foot travel trailer and the springs made a gigantic difference in the way it handles the trailer tongue weight. Should’ve done this year’s ago!
3Cheers!
Elliot K Umberger –
Huge difference. I had the two inch rear spacers in with the original springs and still had rear sag. After installing these springs I gained exactly 3 inches in height measuring at the rear fender flare. Truck drives and handles much better. Much stronger and will definitely handle a load. Very glad I went with this product.
Splcutty –
Works wonders. Definitely gave my saggy tail a lift. Would recommend for sure.