ICON 1.5″ Lift Rear Expansion Pack Add a Leaf 1995-2023 Toyota Tacoma

SKU: 51100
(16 customer reviews)

Description
ICON 1.5″ Lift Rear Expansion Pack Add a Leaf 1995-2023 Toyota Tacoma

ICON 1.5″ Lift Rear Expansion Pack Add a Leaf for 1995. 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023 Toyota Tacoma

Part: 51100

Includes: 2 Add a Leaf Springs, 4 U-bolts and hardware.

Overview:

This 3 Leaf Progressive Add a Leaf Kit comes complete with U-bolts and Center pins for an easy install. This add a leaf kit will give your Tacoma / Tundra 1st gen 1.5″ of lift after installation. Just remove the factory overload and say good bye to that rough factory ride.

Installation instructions from our customer:

16 reviews for ICON 1.5″ Lift Rear Expansion Pack Add a Leaf 1995-2023 Toyota Tacoma

  1. Dave

    Put these on a 2004 TRD Tacoma that had 198k. Recently replaced rear springs and then added these at the same replaced front struts. Raised truck about an inch, got rid of the old tilt. Recommend.
    Shipped on time.

  2. keonijumawan

    Easy install, icons only been on for a week and still holding up good.

  3. MICHAEL

    Installed on my 16 Tacoma. I have king 2.0 in rear and ride was super soft. Once I installed these completely changed my ride and rid e height. My truck is almost smoother that my rzr is and that’s not a ok ber exaggeration. Rating 4 stars because paint on leaf springs was chipping off really bad

  4. Antonio

    Good AAL pack, just a little pain with the install and having to grind off clamps on my stock leafs to get them on my ’16 Tacoma. Rides smooth and good lift though.

  5. Dave

    Installed the package two days ago. Vehicle rides much better. Added about one and one half inches to the rear suspension height. I did not want a lot of lift. Just more weight capacity. I am happy! Thanks.

  6. Kyle

    The springs came with a lot of paint chipped off, so I had to touch up the paint in several places. This is advertised as a 1.5″ lift, but I only gut just under 1″. Now I have to decide if I’m going to take everything apart and come up with a solution or deal with the lack luster height. Otherwise, it was fairly simple to install. Just be prepared to cut some stock leaf spring clips, as they interfere with the clips on the AAL.

  7. Tykie Gortat

    Super awesome! Running them on my 03 Tacoma 4×4 for about 2 weeks now and they are far better than the stock ride quality! And quite a bit more travel! I definitely wouldn’t make the mistake of running blocks again!

  8. jay

    fast shipping and easy install!

  9. Daniel Houle

    tacoma 2009 dclb ride smooth,2inch of lift with overload leaf springs. Replace my ready lift block with ICON and vibration is gone. Verry happy

  10. Tim

    Happy with the results. Lift on my Tacoma was 2.25 inches but I left stock overloads on. Only complaint would be they are harder to install then the video says.

  11. Gray Huffman

    I am an automotive mechanic and my personal vehicle is a 2013 Toyota Tacoma TRD Sport crew cab longbed. I put Bilstein 1500 struts (set on the top setting/slot) on the front to level my truck so I can run 295/70/17 tires after I trimmed/notched the cab mounts in the wheel well. After I installed the Icon leaf spring the rear sat lower than the factory leaf springs did by negative .25 inches. I read all of yall’s comments saying the leaf’s would lift the rear 1-1.25inches higher and handle more weight. Sadly it did not at all. Unless mine are just defective leaf springs don’t waste your money on these thinking they will lift it.

  12. Matt

    These are a great AAL pack. They lifted the rear of my truck about 1.5 inches as described. Took myself and a friend about 3 hours to install both sides and neither of us are very mechanically inclined. Only reason for 4 stars in they arrived with the paint chipped in multiple areas, so I had to spray with rustoleum the night before install. Not a big deal to me, if it is to you then I would not recommend buying these as it seems many people have mentioned them arriving this way. Other than that I would highly recommend these for your truck

  13. Brad Barritt

    dude, great video. you were very thorough and good camera .. so many videos make me dizzy from bad camera work…

  14. Sang pham

    Looking good on my 2022 TRD Sport. Installation was fairly easy. Wish it comes with the brake line mount. Not sure what to do with the oem bracket dangling at this point.

  15. peter w

    This does not work on a 2wd tacoma.

  16. DK

    The lift runs between 1 and 1.5 inches, depending on how old your springs are and how much added weight you have. I combined these leafs with Pro Comp’s 1″ block kit, Bilstein 5160’s in the rear and 6112’s in the front on the highest-lift recommended setting. The ride is better than stock and I run 285 BFG ATs. I do run a shell/topper and my rig sits perfectly level. I did not add shims in back nor UCAs up front and it’s aligned perfectly and I get no vibrations. This is my 2nd Tacoma I’ve put this same lift on.

Add a review

Your email address will not be published. Required fields are marked *

$227.95

In stock

In stock